VitalWear VitalWrap System Manuel d'instructions Page 6

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 15
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 5
1. Ensure the top of the appliance is properly installed and the
handle is fully engaged prior to carrying the appliance.
2. DO NOT carry this appliance by supply cord or use cord as a
handle.
3. Keep the cord away from heated surfaces.
4. Never operate the appliance without the Fluid Canister, the Top
Assembly, the Tubing Set, and the Wrap completely connected.
5. Never operate the appliance with any foreign objects in the
Fluid Canister.
6. Never drop or insert any object into any opening.
7. To disconnect, turn off power ( position), then remove plug
from outlet.
8. Use cooling surfaces carefully. Do not use over insensitive skin
areas or in the presence of poor circulation. The unattended use
of cooling by children or incapacitated persons may be dangerous.
Consult your physician.
9. DO NOT stand on or in the appliance.
10. Do not use while sleeping or drowsy.
11. Do not place the appliance or operate the appliance while it is
on a surface more than 3 feet above the floor.
12. Unplug this product before filling. Fill with water and ice only.
Do not overfill.
13. Do not operate without water.
14. Do not operate with hot water.
15. Do not place the Tubing Set, Power cord or use any wrap other
than the Cervical (neck) wrap around the neck.
16. Do not charge battery pack except in specified conditions.
17. Do not heat battery pack above 212ºF (100ºC).
18. Do not short circuit the battery pack.
19. Do not crush or modify the battery pack.
20. Do not overcharge the battery pack.
VitalWear does not have an authorized service center. However,
if this appliance is still under warranty, return it to the VitalWear
Consumer Service Department at 1.800.553.4081.
Please refer to VitalWear for proper disposable of this product.
9
8
Amendment 2, Sub-clause 6.8.2 a (EMC):
This equipment has been tested and found to comply with the limits
for medical devices to the IEC 60601-1-2:2001. These limits are
designed to provide reasonable protection against harmful interfer-
ence in a typical medical installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference
to other devices in the vicinity. However, there is no guarantee that
interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to other devices, which can be
determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving device.
Increase the separation between the equipment.
Connect the equipment into an outlet on a circuit different from that
to which the other device(s) are connected.
Consult the manufacturer or eld service technician for help.
Unpackaging Information
Your RecoveryWrap System is 100% Quality Tested. When unpackag-
ing your new system:
• it is normal to nd moisture in the RecoveryWrap uid canister due
to Quality Testing, and
• it is normal to nd moisture inside the RecoveryWrap canister due
to Quality Testing.
Please ensure the RED dip tube caps are removed prior to operating
your new RecoveryWrap System. You may nd uid in the RED caps
due to Quality Testing.
During some air freight shipments in pressurized containers, the
RecoveryWrap System may develop a vacuum between the top and
uid canister due to the anti-spill seal. If this does occur, insert a at,
blunt object such as a large paper clip between the top and uid canis-
ter to overcome the seal. Please contact VitalWear at 1.800.553.4081
if this is not effective.
Vue de la page 5
1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Commentaires sur ces manuels

Pas de commentaire